versago:versago_upgrade
This is an old revision of the document!
Table of Contents
Versago Upgrade
Upgrade Preparation
- If you are using HTTPS Redirect to allow users to simply use the URL (e.g. https://versago.yourdomain.com) to access Versago, you should disable the redirect before beginning the upgrade.
Information You Will Need
- The name & password for an active Versago administrative user.
- If your site is using SSL, you will need to know the name given to the SSL certificate used by Versago.
Upgrade
- Execute the “setup.exe” file in the upgrade package. This will start the upgrade process.
- Always use the right-click > Run as administrator option to execute the upgrade.
- Click [Next] to continue from the first screen that is presented.
- Review the End User License Agreement (EULA) that is presented.
- Indicate your acceptance by selecting the appropriate option.
- Click [Next] to continue.
- Select the “Do not accept” option if you do not accept the EULA.
- The upgrade will terminate.
- Confirm or change the installation location of the Versago files.
- Click [Next] to continue.
- Confirm the previous installation options
- The website name should be “Versago”. This should not be changed without consultation with Third Wave technical support.
- The “Enable SSL” checkbox should be selected if SSL is being used.
- Confirm the port being used for Versago.
- Information about appropriate ports is found in the Installation page.
If have selected SSL and you have already registered your certificate in IIS, you should select the desired certificate from the drop-down
- Click [Next] to continue.
- Various screens will be displayed as different components are installed. This may take a few minutes.
- The final installation page provides the option start Versago.
- Click [Finish] to complete the initial installation.
- The Versago home page is opened using “localhost.”
- There is a delay of several seconds while the initial configuration completes
- Once the Versago login/password fields are accessible the basic installation is complete.
Depending on your browser, you may receive a message that the “site is not secure.” This generally occurs when you are using https. There should be an option (you may have to look for it) to acknowledge the issue and continue. This most commonly is found with the Chrome and Firefox browsers.
Final Upgrade Steps
- If you are using HTTP Redirect you may need to adjust the redirect information and re-enable it.
- The upgrade process may cause Versago to “lose” the company logo that may have been configured. It will revert to the default Versago logo. Reapply your company logo in the Customization section of the Versago Admin console.
versago/versago_upgrade.1564593547.txt.gz · Last modified: 2019/07/31 13:19 by runger
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
