versago3:system_settings
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
versago3:system_settings [2025/03/24 15:21] afernandes [Bizweaver Token] |
versago3:system_settings [2025/05/16 12:37] (current) afernandes [Email Server] |
||
|---|---|---|---|
| Line 28: | Line 28: | ||
| ===== Email Server ===== | ===== Email Server ===== | ||
| - | The settings are used to configure a connection to an SMTP (email) | + | Versago now supports two methods for configuring your SMTP server |
| - | {{ :versago3:email01.png? | + | Go to the // |
| + | |||
| + | The settings below are used to configure a connection to an SMTP (email) server. | ||
| + | |||
| + | ===SMTP Basic Authentication=== | ||
| + | |||
| + | {{ :versago3:email1.png? | ||
| * Only one SMTP connection can be defined for a Versago installation. | * Only one SMTP connection can be defined for a Versago installation. | ||
| Line 44: | Line 50: | ||
| </ | </ | ||
| + | ===Oauth Authentication (For Exchange Online Only)=== | ||
| + | OAuth authentication is a more secure method that allows you to authenticate using your Microsoft Exchange Online credentials. With this method, you will need a Tenant ID, Client ID and Client Secret values. | ||
| + | {{ : | ||
| + | |||
| + | * Email Address: The email address you want to use for sending emails. | ||
| + | * Tenant Id: Your organization' | ||
| + | * Client Id: The Client ID from your Microsoft Azure Active Directory application. | ||
| + | * Client Secret: The Client Secret associated with the Azure Active Directory application. | ||
| + | *Test Email is used to verify your settings. | ||
| + | * Enter a recipient email address and click [**Send**]. | ||
| + | |||
| + | <WRAP center round important 90%> | ||
| + | Make sure that you have registered the correct application in Azure Active Directory and that the Tenant Id, Client Id and Client Secret are valid | ||
| + | </ | ||
| ===== Password Reset ===== | ===== Password Reset ===== | ||
| This setting is used to configure the message that is sent when a user clicks the “Reset Password” link on the Versago home page. | This setting is used to configure the message that is sent when a user clicks the “Reset Password” link on the Versago home page. | ||
versago3/system_settings.1742844083.txt.gz · Last modified: 2025/03/24 15:21 by afernandes
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial 4.0 International
